Workshop
Ask a question

Topics with Label: Tools and Materials

cassieandrews
Building a Reputation
15 replies

After the previous owners of our house subdivided the block, our backyard was left unfinished. Together my partner and I set out to transform the ba ...

Narla
Building a Reputation
2 replies

We have recently purchased two Holman retractable hose reels however the front garden tap is located in a very obvious location so the reel would be o ...

Snowgum
Just Starting Out
2 replies

Hi, I want to lay artificial turf on top of my existing boulder wall. I’m thinking I should secure the edge rocks first but am unsure what the best wa ...

Matthewsl
Community Newcomer

Hi, We have a back fence that has a gap underneath. Unfortunately the neighbour behind's land drops about 60-80cm below ours. Our dirt is falling int ...

ricm
Just Starting Out
12 replies

Hi there, Any advice on this would be greatly appreciated... We are building a new deck in an area with pavers in the back. We have an uneven area of ...

Case
Just Starting Out
6 replies

Hello, I'm looking for suggestions on how to tackle the sloped area between my fence and driveway, especially since there aren't enough retaining wa ...

martyjames
Just Starting Out
6 replies

After further research and helpful input from you guys i am now planning to build an approximately 3m x 3m deck (no pergola) over a slightly sloping c ...

CherBear
Just Starting Out
1 reply

Hi there I am wanting to construct a pond using an old plastic bath. Would Crommelins pond sealer be the best product for this surface? There are n ...

Jackson5
Just Starting Out
6 replies

Rear yard 2 slabs coming off the house. New fence 1800 H will be installed along the rear. One slab only slightly raised from ground but other nearly ...

kads
Just Starting Out
2 replies

I would like to retain the character but not keen on the swirly pattern on the columns nor the very fancy bits at the top, would prefer something stil ...

Kels_46
Just Starting Out
2 replies

Needing advise on securing the bottom of our gate so the dog can't crawl under. We need to be able to use the gate as well. Also we live in a rental ...

nila
Just Starting Out
7 replies

Hi I have a brick fence which sits on some sandstone supports. The inside of one block has a large chip and crack. I am going to build a garden in tha ...

revingbev
Just Starting Out
1 reply

have a colour bond fence and want to put lattice above the fence And attach to post

vas90
Getting Established
7 replies

Hi,Have been looking at ways that I can limit the amount of water around the the first level of bricks in the images. Would it cause any issues to do ...

Haydn1
Just Starting Out
1 reply

What happens if I don't have a gas bottle to swap and I require at least two?

luckyphilh2os
Just Starting Out
8 replies

I need something better than glue. Any suggestions please. Hello. Recently we had our roof tiles replaced.The roofer used the concrete roof over the ...

ivanptr
Making a Splash
1 reply

We recently hired tradespeople to install a carport, and one of the posts was screwed onto the current  driveway, causing a slight widening of the ex ...

Dinomo
Just Starting Out
4 replies

Hi, I have read some good advice on removal of urine smell from artificial grass, we have a small back yard that has small white stones which has soil ...

mahendrabhatpr
Just Starting Out
1 reply

Hi,I am looking to install Smart main door Deadlocks and I was told that our Apartment main door is fire safety door and not all locks are eligible. I ...

DannyN
Just Starting Out
3 replies

Hi, Our clothesline is rusted and broken. Can you please recommend a suitable replacement option? Additionally, would it be acceptable to retain the t ...

steveof2620
Cultivating a Following
5 replies

Hello, I have installed a modular decking in my courtyard out back using the good times decking solution from Bunnings. I am pretty sure I used the Me ...

manninkin33
Just Starting Out
1 reply

What is the best timber to use on my rendered home externally around the windows to create a frame lock?

PKUTZ1
Just Starting Out
2 replies

   

ashwin23
Just Starting Out
1 reply

 does anyone know the name of this screw head? I'm looking to remove a few panels from my deck and couldn't find a drill bit for this. Thank you