@daveh1224 usually it's a 2.4/5ghz issue.
If you can place your modem into 2.4ghz only or setup a guest network with 2.4ghz only and try connecting ...
@chrisduffield79 @MitchellMc
Hey Chris,
Your hot water system will be connected at 15amp CB as 3.6kw / 240v = 15a so you have a couple of choices and ...
@wommamukurta where did you buy the battery from?
If from eBay or AliExpress the. Probably no it's a different connector and you need to cut the old ...
@MitchellMc and @KMc1 unfortunately the maximum demand is something that needs to be assessed by an electrical contractor, there are several different ...
@Alan4 @EricL
There are standalone receivers out there for your brand gate opener that allow you to wire into the extra low voltage terminals of your ...
@Dithu @JacobZ @EricL
Hi mate,
It's been a little while since I have set this up and I have moved it around on a few AC units but I believe it is w ...
Hi @stevesmith2107
Is this the sort of Grid Connect remote control you are after?
If so, please refer to Page 12 of this Forum: "4 Gang Smart Switch ...
@CSParnell This is the way. Simple, relatively inexpensive and provides a very precise method for plumbing the post. How it's done on pretty much ever ...
Flood Detector Part 3 of 3
Having decided NOT to use the Tuya Smart Wifi Water Leakage Detectors for their intended purpose, I wondered if they coul ...
Hello @ADWilson23
Welcome to the Bunnings Workshop community. It's wonderful to have you join us and thanks for sharing your question about your se ...
PAYS NOT TO OVERTHINK THINGS:I thought I would share my experience constructing a little ‘two channel smart switch’ project . . . I built this little ...
@daveh1224 usually it's a 2.4/5ghz issue.
If you can place your modem into 2.4ghz only or setup a guest network with 2.4ghz only and try connecting ...
@chrisduffield79 @MitchellMc
Hey Chris,
Your hot water system will be connected at 15amp CB as 3.6kw / 240v = 15a so you have a couple of choices and ...
@MitchellMc and @KMc1 unfortunately the maximum demand is something that needs to be assessed by an electrical contractor, there are several different ...
@Dithu @JacobZ @EricL
Hi mate,
It's been a little while since I have set this up and I have moved it around on a few AC units but I believe it is w ...
@sezz @TedBear @JacobZ if you need to join the cables just make sure you use a gel filled lock it stops corrosion.
https://www.bunnings.com.au/k-rai ...
@w0mbat
Tuya / Grid Connect Smart Devices and 2.4GHz Wi-Fi Requirement
Why 2.4GHz is Required for Initial Setup (Not 5GHz or Dual-Band)
Hardware and ...
