Workshop
Ask a question

The Bunnings Workshop community can help with your home improvement projects.

Plumbing

diy_vvv
Growing in Experience

The tap is leaking. I can’t get to the washer  I tried holding steady with one hand and a wrench and turning with the a wrench in the other - it won’ ...

jenjmurph89
Community Newcomer
1 reply

Hi team bunnings We recently got our bathrooms renovated and the tradesmen failed to tell us to swap out the drains for new ones. Is there anything w ...

pauly85
Just Starting Out
7 replies

I went up on the roof and notice that there was a gap between some colorbond sheets. Looking for some recommendations on what would be the best way to ...

tommymac
Getting Established
6 replies

  Hi gang, Have recently had the roof repointed and some damaged tiles replaced. The pointing looks good and weep holes have been drilled but I am ...

diydunce
Just Starting Out
1 reply

I was trying to replace the valve & washer on my dripping bathroom tap.I did the cold no problem, the tap bonnet on the hot tap is so tight/corroded t ...

lucy08
Just Starting Out
3 replies

I paid a licenced tradesman update a laundry and cut a doorway between the bedroom and laundry. I have already Paid Over 9k and extra for the sink, ta ...

kauspet
Just Starting Out
3 replies

Hello, I've recently moved into a new place and encountered a washing machine drain outlet setup I haven't seen before. The outlet is significantly la ...

knickknack24
Getting Established
5 replies

The tap on my apartment balcony is dripping even though it is tightly closed. I think I need to change the washer but I don't know how to pull apart t ...

Adam4
Just Starting Out
1 reply

Hi there, I'm hoping a plumbing wizard can help me find the product or solution I need. My pop up bath tub waste has siezed up with corrosion. I need ...

pash81
Cultivating a Following
7 replies

Hi, I have this old bathroom tray which is rusting. The shower drain has also rusted. Any ideas how to fix it or is it easy to replace it? Any water ...

jmo_syd
Just Starting Out
3 replies

  Been trying to work out a fix for this broken spout. It seems to have just come loose from the base and now water leaks out the join when the tap i ...

HelgaDaisy
Growing in Experience
6 replies

Hi  I want to install an area to wash my dogs in the laundry. Ideally, I'd like to replace my existing cabinet with a sink with a base cabinet w ...

AlanM52
Getting Established
3 replies

The soothing sound of falling water accompanied by a distinct "clack" or "donk" sound. This was a 2012 project so some of the stuff looks a bit primit ...

sum1989
Getting Established
1 reply

Hi, I am planning on adding a shower to my laundry room and doing some changes. I might be getting plumber, electrician and waterproofer for the job. ...

sum1989
Getting Established
3 replies

 Hi, I am looking to change this sink to a bigger one. 1. Is there a sink that will work without impacting the door? 2. If I were to add tiles, how ...

beemerx65
Growing in Experience
6 replies

hi all. I have a 90’s bathroom that unfortunately the tap seats have finally gave way. As I haven’t got the budget or the time to fully renovate. He s ...

a_amir
Just Starting Out
10 replies

Greetings, lovely community. I have a colorbond section on a tiled roof. As seen in the photos, the way the colobond is connected to the tiles is vi ...

JRJS
Just Starting Out
2 replies

  Hello all! I just had a flat roof installed and I was wondering if the flashing is done right? Should these screws on the top end (just below the ...

CGamage
Just Starting Out
3 replies

Hi   Down pipe has detached from the ground pipe. As you can see the concrete slab has shifted. How do I fix this without drilling into the concrete? ...

user123
Getting Established
3 replies

Hi, We've got Mondella 100mm Concerto Stainless Steel Square Floor Grate in our shower. Link. How do I remove this to clean the inside? I can't lift i ...

sithyatawatta
Just Starting Out
2 replies

Can someone tell me why the water coming out of the washing machine is leaking out of the little spout on the left? Is this supposed to be open? Do I ...

RenoFun
Finding My Feet
2 replies

My missus isnt tall enough to grab the showerhead from the current installed height... I am wondering if there's a product I can place to hold the sho ...

wbui1501
Just Starting Out
4 replies

I've had this leaky tap in the bathroom for a while now because I can't figure out how to open the tap up to get to the washer I need to replace. I'v ...

jimbo2907
Just Starting Out
3 replies

I have a theoretically 'new' tap installed by a licensed plumber at a huge cost. I want nothing more to do with this guy. It is a noisy tap and wish t ...

Why join the Bunnings Workshop community?

Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects