Thanks everyone for the help.
i finally got stuck into it. Have made a lot of little mistakes along the way - and it’s not perfect - but it’s better ...
Thanks @MitchellMc . Could I just use H3 for the bearers? They will all be above the ground on small supports now (so not in direct contact with the g ...
thanks @JacobZ - I am online now ordering my timber - and just realised I can’t get H4 140x45 at 5.4 lengths (I can get at 4.8 on special order only). ...
Thanks @JacobZ .
I have a clearance of about 250-300mm height to work with (so 140 bearers +90 joists + 20 composite decking = 250 ) seemed to be a ...
Thanks @JacobZ and @Dave-1 .
i have been struggling to find a tool to help me draw up what I am trying to do. So here is a rough sketch. The width of ...
thanks @Dave-1 and @EricL .
I have decided to dig out a bit more soil ( and drain through the side of my pit rather than over the top)., I am now pla ...
Greeting guru’s. last time I asked about a deck I got my head in a spin and ended up doing a knock down and rebuild because “it was easier”.
I now hav ...
Hi @qroozn, Your plan looks solid to me, and it will certainly ensure everything is well-supported. Having a two-tiered deck frame means you will have ...
Welcome to the Workshop community @qroozn. Many thanks for your question, I'd be happy to start the discussion.
I've taken the liberty of using a ca ...
Thanks @MitchellMc . Could I just use H3 for the bearers? They will all be above the ground on small supports now (so not in direct contact with the g ...
Thanks @JacobZ .
I have a clearance of about 250-300mm height to work with (so 140 bearers +90 joists + 20 composite decking = 250 ) seemed to be a ...
Thanks @JacobZ and @Dave-1 .
i have been struggling to find a tool to help me draw up what I am trying to do. So here is a rough sketch. The width of ...
thanks @Dave-1 and @EricL .
I have decided to dig out a bit more soil ( and drain through the side of my pit rather than over the top)., I am now pla ...
Greeting guru’s. last time I asked about a deck I got my head in a spin and ended up doing a knock down and rebuild because “it was easier”.
I now hav ...