Thanks Mitchell. I had already purchased these as when I went into store and was told they should be square edges. I wonder if I can just flip the ben ...
Thanks all. I am considering just getting a new benchtop as two installers have now said they’re unable to butt join!
I am looking at the practa solu ...
Got it, thank you! I will look into the plugs. Our current masonry drill bit is 6mm wide. Do we need to change our drill bit size?
based on the photo ...
Thank you! We used that drill bit and masonry screw for our base cabinets and they held up well. The wall cabinets themselves are approx 10kg each, so ...
Hi all,
Thanks for all of your help so far during our diy kitchen reno it’s been great! Im on my last stretch now and wanting to tackle the wall cabi ...
Got it thanks, would I need a significant amount of excess for this cut since the bottom is a different colour? So I can’t just flip it over to connec ...
Hi @JR2
1. In the first photo it shows a few old leftovers from the original kitchen I dismantled. The left hd a pale blue polycarbonate splashback ...
Thanks all. I am considering just getting a new benchtop as two installers have now said they’re unable to butt join!
I am looking at the practa solu ...
Got it thanks, would I need a significant amount of excess for this cut since the bottom is a different colour? So I can’t just flip it over to connec ...
Hi Dave,
they are laminate benchtops. The front end is straight at the bottom but towards the top there is a slight curve where the 90 degrees is th ...
thanks! I’ve attached some photos below. The edge facing towards the front is curved and the back is a square. So joining the two will leave a gap.
t ...
I have a 28mm thick worktop that has a slight curve on the edge which I am using as part of a low budget kitchen renovation. This will be my kitchen c ...
Thank you so much this has been super helpful!! I will get the 8mm masonry drill bits and also the 8mm Ramset fastener for the walls. Did you use a ...
Here are some photos where the gap seems quite large, we haven’t removed it all yet just because we weren’t sure if we would be able to fill the gaps ...
