-
How to repair concrete driveway edging?
My driveway edging was formed through a continuous casting some 25 years ago. The edging boarders the aggregate driveway and the grassed area next to the driveway. Over the past years, the concrete edging has started to break away (see images). My goal is to clean, patch and paint the edging to restore the finish. I wanted…
-
How to rejuvenate oxidised anodised black window frames?
Hi all, I’m looking for some guidance on how to address a problem with the external black anodised frames on my house Stegbar windows. The windows were installed about 25 years ago, and over time, the anodised coating has developed signs of oxidation. The underlying aluminium is still in good condition, but the black…
-
How to fix a fibre cement crack at a join?
I'm hoping the community can assist with their experience. I have an external building clad in fibre cement (I assume to be blue board). It has been up for approximately 10 years and the wind/weather has caused one of the board joins to crack, letting in moisture. I am trying to determine the best process to fix and seal…
-
How to cut a nylon rod?
Hi Bunnings Community. I have a length of 20mm nylon rod that I need to cut into 20mm lengths. I am thinking of using my Ozito 210mm Mitre Saw. That should give me nice straight ends. Wondering if there are any thoughts on the best saw to use? I would expect a high tooth count and small kerf. Thanks.
-
Drill for Self Drilling Screws
I am planning to line a Colorbond shed, screwing 12mm plywood to the galvanised C section girts. I’ll likely use 40mm self drilling, counter sunk screws with a phillips head. I’m unsure which is the best drill for the job, a hammer drill or a drill with a clutch. I have a couple hundred screws to fix. I’d appreciate…
-
How to prevent water ingress with expanding foam?
I’ve built a Colorbond shed that is in a relatively exposed position. During heavy rain and wind, water can get through the gaps in the ridge capping (see image). I was aiming to inject some low expanding foam to close the gaps. However, as I know expending foam, the canisters need to be used in the vertical position. If I…
