-
How to install curtain rod into ceiling?
Hello, I would like to install a curtain rod on the ceiling going halfway across the pictured opening, to hang lightweight curtains. I know that when installing load-bearing stuff into the walls, you should do it at a place where there is a stud. Are there similar studs in the ceiling, and if not, is there any workaround…
-
How to patch ceiling holes from light fixtures?
Hi, We are planning to replace a few light fixtures in the house with the help of an electrician, however some need to be moved to a different spot and others changed from a track light/oyster light to pendants. Therefore, we anticipate that there will be holes left by the old light fixtures (photos attached). Would…
-
How to create an 1.8m long monitor riser?
Hi, I would like to create a computer monitor riser similar to the picture, but 1.8m long instead to go the length of the desk. What products would be best for this? I realise that it may be difficult to find perspex brackets like the picture, so might have to use wooden blocks instead. In that case, is there a way to…
-
How to fix screws spinning inside metal wall stud?
Hi, I've just installed this instrument holder but the screws are spinning around and not fully tightening. Here is what I did: * Used a stud finder to mark the wall in the correct place. * Used the smallest drill bit (shown below) to make two pilot holes. It was narrower than the threads of the screws. * I know it went…
-
How to build a picture frame medicine cabinet?
Hi, I was hoping to do something like this with a picture frame of this size and colour, but am unsure of which timber products to choose that will roughly match the shade and also be adequate to hold the weight etc. The cabinet is only intended to hold medicines, so nothing particularly heavy. Thank you!
-
How to cut cabinet to fit up the stairs?
thinking about cutting it horizontally just under the top drawer as it's where a lot of the pieces are joined together anyway. would be grateful for any advice on: - what type of handsaw to use - how to stick it back together - how to best disguise the "seams" thanks
