Thanks @MitchellMc After photo was 1st coat. I did second and then waited 2-3 hours to do water beading test.It was so satisfying to see water not dis ...
Weather was good this weekend for cleaning and coating.Work in progress.First coat done.I'll do another in 2 hours.I read a tip that to see if another ...
Thanks @MitchellMc Happy New YearI have https://www.bunnings.com.au/irwin-20oz-fibreglass-hammer-1991009_p0065673 I tried nail punch technique on some ...
Thanks @MitchellMc I bought these https://www.bunnings.com.au/trojan-3-piece-nail-punch-set_p0423026 .I watched https://www.youtube.com/watch?v=CaBkdZ ...
HiDeck is not in good condition and I want to fix it.
I saw some staining and oiling videos.It looks like I need to stain it but just wanted to mak ...
If that's the first or second coat in the after images, then it's looking pretty good @legopoint. If it's the first, I'd do another, but if it's the s ...
That sounds like a plan, @legopoint. By oiling the deck, you'll preserve the timber and stop it from deteriorating. Sanding the deck just improves the ...
Hi!Once you have suitably prepared the deck (repair, sand, clean) you can then look into sealing. Sealing will help rejuvanate and enhance the beauty ...
Hi @legopoint It is vital that the surface of your timber deck be sanded properly. Failure to do so will result in poor oil absorption and an uneven ...
Hi @legopoint,
You might like to share a wider shot so we can see more of your deck, but from your first photo it appears that you have uneven wear ...
If you do decide to go with a vacuum @legopoint, a wet & dry workshop vacuum would be the way to go. With adaptors, then can be connected to various t ...
Hi again @legopoint Something in your post has only just registered with my tired brain ... the need to get a vacuum cleaner for the dust etc. Depend ...
Hello @Tyro
Let me tag @Dave-1 to make sure he's aware of your question. When cutting timber panels and they are supported underneath with your saw ...
Thanks @MitchellMc After photo was 1st coat. I did second and then waited 2-3 hours to do water beading test.It was so satisfying to see water not dis ...
Weather was good this weekend for cleaning and coating.Work in progress.First coat done.I'll do another in 2 hours.I read a tip that to see if another ...
Thanks @MitchellMc Happy New YearI have https://www.bunnings.com.au/irwin-20oz-fibreglass-hammer-1991009_p0065673 I tried nail punch technique on some ...
Thanks @Tyro I was thinking of getting one which could be attached to the tool but your idea is not bad while starting out.I think I probably have one ...
Thank you very much @Tyro , @MitchellMc @Dave-1 @EricL @Noyade I have a lot to learn.Design shared by @EricL looks interesting but I don't have enoug ...
This low-level deck using Ekodeck composite boards covered a concrete area and required pavers to support pedestal feet on an unconcreted section.
T ...