Hi @MitchellMc, the gate height is 1.81m, I'm 1.77m tall and it feels a bit too low for my liking to have a horizontal bar across. It might be somethi ...
The ratchet straps did the job, probably too easy which tells me it will go back soon or eventually. As we don't use that gate, might buy myself a bla ...
Thanks all for all the useful help and advice. @EricL I've attached more photos to show the whole gate and the hinges. From the front, the spirit leve ...
Looking for any advice or direction to tackle a problem with one of my gates.
The gate pole on the neighbours side is leaning enough away so the latch ...
Hopefully, you can pull the top of the slanted post towards the other and close the gap with the ratchet straps @Timfc. If so, you can then screw a Me ...
A band-aid solution @Timfc - if you have a 9" grinder and can weld, or know someone who can.
With a cutting disc installed - slice though three sides ...
Hi @Timfc,
If it’s a similar solid post to this one, I’d be inclined to at least try using a heavy-duty ratchet strap between the tops of both posts ...
Hello @Timfc
Welcome to the Bunnings Workshop community. It's sensational to have you join us, and thanks for sharing your question about your meta ...
Hi @Timfc
My only advice is the same as @EricL which would be to break the exposed agg and work your way down to remove the post and start again. T ...
Hi @MitchellMc, the gate height is 1.81m, I'm 1.77m tall and it feels a bit too low for my liking to have a horizontal bar across. It might be somethi ...
The ratchet straps did the job, probably too easy which tells me it will go back soon or eventually. As we don't use that gate, might buy myself a bla ...
Thanks all for all the useful help and advice. @EricL I've attached more photos to show the whole gate and the hinges. From the front, the spirit leve ...
Looking for any advice or direction to tackle a problem with one of my gates.
The gate pole on the neighbours side is leaning enough away so the latch ...