Whatever the block size, I'm sure I can accommodate it and the length.
For the end - I was thinking of drilling curtain weights and welding to the blo ...
Morning @Mar1mot
More than happy to help - no fee required, just the fun in trying.
Can you please show us a photo of the bed fitting? Apologies fo ...
Good morning @stella
Just a desperate thought. If you turn the table frame over, is there a removable cap on the corner?
And if there is - and once ...
G'day @Mar1mot
I have those bolts from an old bed and have no use for them. Doubt I could find the nuts though (I will look).
I can make those thre ...
Thanks for the insights gents. I bit the bullet and had a crack, no facia board I just fastened gutter brackets to the ends of the rafters, had to use ...
Welcome to the Bunnings Workshop community @Mar1mot. It's fabulous to have you join us, and many thanks for your question about bed frame bolts.This t ...
Hey @Noyade you are a gem! So so happy with what you have created for me and for your kindness and skill. I look forward to receiving my bespoke lette ...
In the best-case scenario, it might look similar to the below, @mody_moozy.
If the varnished surface has faded or is in poor condition, you could re ...
Whatever the block size, I'm sure I can accommodate it and the length.
For the end - I was thinking of drilling curtain weights and welding to the blo ...
Morning @Mar1mot
More than happy to help - no fee required, just the fun in trying.
Can you please show us a photo of the bed fitting? Apologies fo ...
Good morning @stella
Just a desperate thought. If you turn the table frame over, is there a removable cap on the corner?
And if there is - and once ...
G'day @Mar1mot
I have those bolts from an old bed and have no use for them. Doubt I could find the nuts though (I will look).
I can make those thre ...
If your inlet valve is in good condition, then I'd recommend replacing the inlet seal, @Noyade. However, if the plastic is aging or has become brittle ...