my name is Antonio, i do up decks for a living and other things around the house.
i'm just going to sugest something to you,
if the paint is hard to remove, i would leave it there, i would use the
same product (if possible, if not at list the same base)
you say yours is acrylic, you could get the same thing, give it a nice send
with an orbital sender, 120 grit and then apply your product,
you may need to do 4 or 5 coats to blend the new and the old, but i'm sure
you could get a nice rusult.
we never know till we try.
Let me also extend a very warm welcome to Workshop. It's great to have you as a community member. It sounds like you have a lot of knowledge and expertise you can share with others. I'm looking forward to reading more of your posts soon. I hope you will also receive helpful information and some inspiration for projects from our community members, too.
Please let me know if you ever need any help getting the most from the site, or have any feedback about how we can make Workshop more useful for you.
Just wondering, how much liquid 8 paint stripper did you use? My house has a deck which was painted grey/blue by previous owner, and i want to strip it back to bare timber to oil it, but not sure how much paint stripper i will need. The deck is approx 8m wide by 4m long.
Thanks for joining in the discussion. I have tagged @DIY_Dan to alert him to your question as its been a while since he created this discussion thread.
I suspect it might be hard to estimate how much paint stripper you will need before you start as Integrain suggests that thick coatings might require more than one application. Let us know how you go.
Let me also extend a very warm welcome to Workshop. It's great to have you join us. I'm sure you will find plenty of helpful information and inspiration from our community members.
My question relates to preparation of the deck.
I'm guessing that both the chemical and pressure spray preparations were not required given the decision was made to sand in the end. Is this correct.
Wouldn't sanding always be preferable to chemical preparation ....... less toxic?
Are you planning your own deck rejuvenation project? Please don't hesitate to hit the Start a discussion button and share details about your deck and its condition if you need a hand from the community about your specific situation.
Hi there @DIY_Dan,
Recognise this is an old post but hope you can help. I see your fixings are nails - were the heads proud of the boards before sanding? How did you find sanding them with nails? We have nails where the heads are proud and I am worried about stripping them if I use a floor sander.
Jeez I wish they weren't nails!!!! If I could easily pull them out and replace them with screws I would. I actually went through and punched the ones that were sitting proud of the surface so that they wouldn't shred my sandpaper. Nightmare.
Welcome to the Bunnings Workshop community @paulrives. It's brilliant that you've joined us and many thanks for jumping into the conversation.
It's fantastic to see @DIY_Dan has already answered your question.
Are your nail heads so proud that they are significantly above the timber's height? Even if they are level with the timber's surface it's generally advised to punch them down before you start. If you do manage to sand a nail head off completely you can run the risk of boards popping up.
If you could share a picture of some of the worst examples I'm sure our members can offer some advice.