Workshop
Ask a question

The Bunnings Workshop community can help with your home improvement projects.

Formal entrance created using single car garage

Nailbag
Amassing an Audience
Nailbag
Nailbag
Amassing an Audience

 

A single garage was sacrificed to create a formal front entrance and significantly enhance the street appeal of this home. It was the winner of best outdoor project in our 2024 search for Australia's best D.I.Y. projects.

 

Main entrance.png

 

The project

 

I bought this house that had the front entrance on a second level at the back of the house. Obviously not ideal, especially when it came to deliveries. The only option in creating a new front entrance was to sacrifice the single garage. This is how how did it.

 

RobP_0-1723446057371.jpeg

 

RobP_1-1723446057439.png

 

Steps

 

Step 1

 
The first step was to apply for a building permit and have drawing submitted, to be able to legally have the entrance classed as a living space.
 
RobP_2-1723446073857.jpeg

 

The ground in front had to be dug out below the concrete slab and a drain installed across the front to ensure no water ingress.

 

Then the roller door was removed.

 

Step 2

 

I ordered a 1100mm solid timber door preinstalled to a jamb with side glazing. Once that arrived I was able to frame out the old garage opening to suit.

 

I needed a hand from a mate with this project in various stages to help lift and position the new door into place.

 

RobP_3-1723446084103.jpeg

 

Step 3

 

Around the same time I was also preparing the external brick work for rendering as they were not flat and needed to be hand ground down.

 

RobP_4-1723446094970.jpeg

 

I fixed blue-board to the out entrance frame which was to be inlayed with a feature stone tile. Then tested the entrance with my first little visitor.

 

RobP_5-1723446094958.jpeg
 

Step 4

 
Next was to render the blue-board, then pre-wire for feature lights and a Ring smart doorbell before installing the stonework.
 
RobP_6-1723446107913.jpeg

 

With the drainage installed and approved I built a small entrance deck leading up the front door and landscaped each side.

 

RobP_7-1723446107986.jpeg
 

Step 5

 

With the external entrance part-finished, it was time to start on the internal space by cladding the brick with plasterboard and building a dividing wall within the old garage. Behind which will eventually be a small living space as part of a new guest bedroom.

 

RobP_8-1723446126947.jpeg

 

RobP_9-1723446126983.jpeg
 

Step 6

 

I wanted to open the staircase up leading to the 2nd main level of the house as it was very narrow.

 
RobP_10-1723446139393.jpeg

 

RobP_11-1723446139388.jpeg

 

RobP_12-1723446139396.jpeg

 

I was inspired by some designs I had seen, and came up with a timber-slated feature that I made from Tassie Oak. Once made, I then cut and prepared the staircase frame to accomodate.

 

RobP_13-1723446139401.jpeg

 

I underestimated how heavy this was and called on my mate to give me a hand to install it. Then I was able to finish the walls.

 

RobP_14-1723446139379.jpeg
 

Step 7

 

The left hand back wall was plasterboard which I finished with a Deluxe texture paint. The right side was MDF panelling, allowing me to fix 19mm x 42mm DAR Pine to.

 

RobP_15-1723446149998.jpeg
 

Step 8

 

I mounted timber blocks to the centre of the wall to fix a round feature miterer to give the impression it was floating off the rear wall. I had pre-run a cable to the back ready for an LED light strip that I wrapped around behind the mirror. 

 

RobP_16-1723446163913.jpeg
 

Step 9

 

Next step was to tile over the old concrete floor with large format tiles.

 

RobP_17-1723446178401.jpeg
 

Then install the skirting, architraves and paint the walls.

 

Step 10

 

Last job was to fit a new feature light and the project was completed.

 

RobP_18-1723446194112.jpeg

 

RobP_19-1723446194116.jpeg

 

RobP_20-1723446194105.png

 

RobP_21-1723446194175.png
 

Tools and materials

 

Materials used in the project:

 

 

Tools used in the project:

 

 

Comments
Dave-1
Community Megastar

Congratulations @Nailbag 

Shaking my head at the level of work and even above that the level of detail that you do. Impressed no end :smile:

 

Love it!

 

 

Dave

Why join the Bunnings Workshop community?

Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects