Workshop
Ask a question

The Bunnings Workshop community can help with your home improvement projects.

How to replace garage door bottom seal?

krishnak
Finding My Feet

How to replace garage door bottom seal?

IMG20211004222918.jpg

IMG20211004222722.jpg

IMG20211004222818.jpg

 hi team iam looking to replace double garage rolling door bottom seal but when checked couldn't match existing with it B&D or moroday bottom seal with item number 4000019 so can you help me based on image which one I should buy as some asking to remove the seal and show the clear edge but I couldn't remove it and it has T ends so couldn't understand how people using U shaped bottom seals

 

JoeAzza
Kind of a Big Deal

Re: Replace garage door bottom seal

Hi @krishnak 

I have attached some photos of where the screw is located on my roller door, once you remove one of the vertical sliding rail, (mine is on the door control motor end), then the screw, if you have one, then you can slide old seal out, once done clean the bottom guide, and install the new seal, make sure you leave an overhang of material, (same amount as the old seal) so it can be screwed back in position. This is how I did mine, you just need to get the correct seal, good luck.

 

Isolate power supply as instructed by @EricL  then remove vertical rail.

IMG_1631.JPG

 

Only one screw on door motor control side

IMG_1627.JPG

 

IMG_1628.JPG

 

 

 

 

 

IMG_1629.JPG

 

 

 

 

IMG_1630.JPG

 

 

Why join the Bunnings Workshop community?

Workshop is a friendly place to learn, get ideas and find inspiration for your home improvement projects