Unless I turn the shower handles off extremely hard, the showerhead drips. I'd like to fix this so the shower handles can just be turned off normally ...
Hello everyone. I have bought a house but I have discovered that the bathroom vanity is mouldy. Have not got a lot of money to do the reno. I feel tha ...
Good evening, Bunnings community,
I have a leaking shower mixer and have been advised that I need to replace the cartridge. Lots of helpful advice and ...
Hi Team,
Im replacing a subfloor in my bathroom and getting conflicting info in what i should be using. Ill list my project below
1950s house with f ...
I have just purchased a new washing machine and the drainage hose doesn't have a rubber end for me to connect to the spigot on the sink waste pipe. Ca ...
Hi! I just got my first home and have found the flanges on the lower taps and outlet in the shower are loose, and don't quite cover the holes in the ...
I have a drop down shower in an old 90’s townhouse but I want to make it level. Don’t really want tiles anymore just an easy to maintain I wanted wall ...
Hi team,
I have a clawfoot cast iron bath tub where the cream paint has peeled off in a section. It was caused by a very slow drip from the tap and ...
Noticed a minor leak along the grout line, coming from the base of toilet bowl. It happens after a flush, so probably unrelated to the cistern.
It's ...
hi I need a new link suite toilet. I don’t wanna spend too much but at the same time don’t want really cheap plastic key seat that bends when I sit on ...
Hi there, the previous owner notched the floor joist of the 1st floor bathroom around 2cm deep to give way to lower shower floor. There are about 3 jo ...
Hi! I recently scored a twin tub washing machine for free from a neighbour who moved out and left it behind. I live in a rental apartment with a very ...
Hi! Is there a way to tighten the part where the shower head sits? As it is very loose and causes the shower head to fall down constantly. Twisting it ...
Hi DIY experts!
Our shower has a glass door with a big gap underneath it. Not sure how to seal properly - we've tried fitting a bottom seal strip ( ...
Can someone let me know if I can just replace the little part that holds (and makes the head adjustable on the rail + pivots the direction of water) a ...