Topics with Label: Plumbing

I have an Everhard / Nugleam laundry trough with a fine crack, leaking. The install for this was *ugly* and I reckon that would void the warranty. ...

I'm after some thoughts/ opinions about newly renovated bathroom in a 1970s unit Am I correct in thinking a piece of water-stop is missing where tile ...

Hi, We own a townhouse and want to renovate our ensuite bathroom. We don't need to change layout or change any plumbing but replace the old stuff with ...

   I need to replace my powder vanity as the plastic has a crack in it. I figured I may as well update it all whilst I'm at it. I want to do most i ...

I pulled off the old toilet seat to unscrew the mounts and discovered there are no screws or bolts, just these bullet head type fittings. I can’t acce ...

Toilet is filling the cistern constantly and running into the bowl. I am trying to open the cistern lid but cannot undo the flush button. Any help a ...

Good evening, Bunnings community, I have a leaking shower mixer and have been advised that I need to replace the cartridge. Lots of helpful advice and ...

Dear All Our basin is type of plastic not ceramic I am looking to replace it with a good ceramic quality one like Caroma ,,,,may be there are other br ...

Unscrewed this shower head to clean it (whole unit bought from Bunnings and all original parts) the head will not fit back on. The piece on top of t ...

Dear Experts Our kitchen sink's tap assembly is leaking as shown in the attached video in the link below Looking to replace it with a premium qua ...

I have just purchased a new washing machine and the drainage hose doesn't have a rubber end for me to connect to the spigot on the sink waste pipe. Ca ...

Hi all, Noticed there was some moisture near the top of my toilet lid. So took off the lid to take a look (see pic). Both toilets pretty much look ...

 Hi! I just got my first home and have found the flanges on the lower taps and outlet in the shower are loose, and don't quite cover the holes in the ...

Hi, my toilet wont flush due to the outlet breaking. What do you suggest?      

          I have an old caroma 230 toilet cistern. I’m sure the seating washer is worn out. How do I remove the outlet valve without breaking it. ...

After reading some previous threads, I suspect it could be the washer that needs to be cleansed or replaced. My question is, what model is this fl ...

I have replaced my existing bathroom vanity with a new one and need some feedback & suggestions for the waste/drain plumbing. I know I should have ...