I'm looking to build some relatively low traffic stairs for the side of our house, total rise is approx 600mm, width around 1200-1300mm.
The Peak P ...
Hi, If I was using 90x45 Treated Pine to build a decking frame (no decking as using WPC decking), what size type screws would I use? I also need to u ...
Thanks in advance for any help with this. I have read a lot of the very helpful existing conversations about insulating deck/patio roofs and think I h ...
I renovated my 1994 Jayco Sprite from top to bottom, including resealing every seam on the exterior, replacing all external fastenings and attachments ...
This is a firepit I made from scratch on a sloping block.MaterialsRender
Cobble stones
Sealer
Concrete
Mortar
Reinforcing mesh/rod
Paint
Sand
Black p ...
Hi, I am looking at installing the Protector pool fence. I noticed the instructions for the in ground posts say dig a 600mm hole which would only then ...
Hi,
I'm tackling what hopefully will not be too big of an ask for my skillset. I have a 25 M long blueboard rendered front fence that is in dire need ...
I plan to use Jack 300mm x 8m Garden Edging - Bunnings Australia to block the bottom gap, but I am unsure how to install it. Do I need to screw it to ...
Hi,
On my balcony have what appears to be spilled render stuck on grout between tiles.
Have tried using 50% white vinegar with 50% water spray and S ...
We have a stenciled concrete driveway and paths that, after several years, started to look weathered and in need of maintenance. To refresh its appear ...
After building our deck last year, it took me another year to finally start and finish our backyard. We have a small space available so I had to utili ...