Hi! I'm building a mudroom bench and shelf as shown in the picture but i'm unsure how to attach it to our walls, i don't want the screws to be visible ...
Following on from My Simple D-I-Y Desk, I now needed a chest of drawers to go with it, for storage of stuff. For this, I started from the inside ou ...
Hi Team,
I'm looking to create my own computer desk as I need something that is slightly different than the standard office desk as my home office i ...
So I've got that DIY itch again and one of the projects on my list is roof ventilation for the summer months, especially with our attic fully operatio ...
What is the ratio of Lime Cement & Sand for laying bricks?..is there an allready pre-mixed bag product?...I'm only filling in a small area above a doo ...
Wondering what i can use to block these gaps in as its letting cold air in, and the heat out.
There between the floorboards and skirting boards, mostl ...
I am looking to build a DIY Coffered ceiling. I am just a beginner in DIY projects. Is there a guide or a video by bunnings team showing how to build ...
Everyone talks about how they built their Barn doors but nobody is talking about how to install the track. For example, when installing the header for ...
Hi team,Looking for some advice around drilling and fixing into old internal brick walls.Firstly, I seem to be very lucky (unlucky) in that I always s ...
With all the working from home in the past couple of years, it was time to upgrade my humble home table to a decent working surface. For this, I've ...
Hi All
Not sure if anyone has any experience for this. I am renovating my bathroom and just took off older plaster board. It is the old type frame tim ...
Good morning,
I want to use one of the walls on the upstairs landing to install a floating desk as it is an area of the house that we don't use that ...
Hi Folks,
I'm a newbie DIY'er here
I'm looking to make a relatively simple WFH desk. For this I've zeroed in on this Beech Laminated Panel from Bunn ...
Hi community,
I did a small DIY project recently to create address sign for my house and thought of sharing it with the community.
I used following ...
A custom built desk for the home office. Built pre - Covid, for home based projects and gaming, this desk was a lifesaver when the pandemic came aroun ...
Well, I've finally had the time to get to my sewing room to do a little reno. What a PITA it was too.
Firstly I had to go thru about 10 plastic storag ...
As much as we like to utilise every material when creating projects, it’s inevitable that we will end up with scraps/left overs. I hate wasting materi ...