Discussion

Hello, I'm helping my sister out as she would like to remove the whole door frame and door etc and keep it as a wall for more space inside for her l ...

  Planning our laundry, can the door go on the blind corner base cabinet as shown in the pic from the designer? If so, how? (As in, where do the hinge ...

  I am installing new Hevea benchtops over existing base cabinets. The installation instructions state the joiners should be used. However, will th ...

My next question is that I want to create a raised garden bed area. It is currently just sand from our new build. What would be the best ground type f ...

I want to remove an existing sliding door and replace it with a wider one which extends further across our balcony. There is a gap of plasterboard a ...

What would be the best soils/stones etc to fill this planter.I want to put rosemary and lavender in it, but feel filling it up fully with soil is exc ...

     I wonder do I still have to apply one more layer onto the putty or I can simply sand it and paint on it.

    Any idea what’s wrong with my lovey Mulberry? We’ve had it for about 6 months, transferred from my sister’s garden. It started very healthy. The l ...

      Hey guys, I am planning to build some backdoor steps, the platform is 800mm in height and i plan to use 2x Peak Black 4 Tread Steel Stair St ...

 how do I fix a leak on this arm in the cistern?

A very simply fix but proved to be effective. This had been on my mind for a very long time and I looked into chemical treatment and even replacing th ...

I am planning a shed to studio conversion of our old, but well built timber-framed metal shed. Size of the shed is 6.4 x 3.4m with steel frame and con ...

Hi guys, I am currently extending and fully renovating a bathroom in a house that is 100 years old. I have couple of questions before I go any further ...

Hi I had some bolts attached to a wall which we were unable to remove so I cut them flush with the wall and used Poly Exterior Powder Filler to fill i ...

Hi all, My kitchen benchtop got burnt by placing hot pot and the surface is not smooth anymore and there is a mark. Refer the photo.     Is this fix ...