Workshop
Start a discussion

Topics with Label: Building and Construction

varununi
Budding Contributor
3 replies

Hey guys, I have an extension of my pergola into my backyard that is supported by a single pole which is now showing signs of rot and damage. I n ...

ponga3
New Contributor
7 replies

g'day guys, new here and after a bit of advice. I'm in the process of planning a small deck build between a pool I've just had installed and my back d ...

AdamK1
New Contributor
16 replies

Hi, Long time reader, first time poster. After a bit of rain last night I noticed quite a bit of water coming in via the gap between the house and the ...

nnaa8287
Junior Contributor
22 replies

  Hello Team, i plan to build a deck outside within the shed area over concrete area. Dimensions are 8 meters x 3 meters. Ground clearance at the en ...

LJ1809
Junior Contributor
5 replies

 For our little outdoor privacy project we’ve purchased this gazebo kit. We are currently building a GoodTimes 3.34 x 3.34 Merbau deck from Bunnings ...

michaelmkchu
New Contributor
7 replies

I would like to attach shade cloth to an iron gate to increase privacy. The gate's bars are about 1.5 cm in width, which precludes the use of butterfl ...

Jimi
Established Contributor
9 replies

I decided it was time to extend my alfresco and build a Pergola. I did a lot of research for this one and found the most efficient way to do it, was t ...

rookabook
Budding Contributor
9 replies

Hi Team I am trying to put together a deck design and am after some guidance. I've read a bunch of these posts and hoping to tackle this project ove ...

425314
New Contributor
3 replies

khusnil_deo
Budding Contributor
1 reply

Hi there, I am after a clothesline that i can "peg" into the ground which can fold. My yard is not that big and I am limited on space on the house wa ...

Shannon
Experienced Contributor
58 replies

Chaks_DIY
Super Contributor
8 replies

Hi all I'm looking to install some screening using some vertical timber posts 100mmx100mmx2.2m I was planning on using screws. Some into the sleeper ...

oraiti
Newbie
1 reply

Does Bunnings sell the sides for the 3x6m Gazebos?

Pala
New Contributor
1 reply

Hi Experts, I have built a deck recently ( a couple of months ago) using Merbau. What I have noticed is that especially during sunny days when we walk ...

hbye
New Contributor
25 replies

I am attempting to extend the height of my colourbond fence and have purchased the extension posts, the extension panels and the capping post with the ...

eventswestjohn
New Contributor
4 replies

Hi all, I noticed that someone below received design info for their deck. Could I ask for the same assistance. Single layer deck. Deck Size is 6m x 6 ...

womby36
Budding Browser
1 reply

I'm a newbie attempting a deck. Above are my basic plans and rough costings I'm a bit overwhelmed at the choice of timber for the joists. I plan to u ...

Yorky88
Super Contributor
38 replies

I just decided on a whim to build my boys a cubby house on the weekend and I just wanted see what other people have done. If you have built a cubby ...

oninpena
Junior Contributor
40 replies

Hi, I am planning on putting a low level composite deck on my alfresco. I have attached some photos of the alfresco where I plan to put the decking. ...

dezion
Newbie
1 reply

I am installing suntuf corrugated to a patio. The house wall is a flat surface, is the suntuf apron flashing ok to use as it just sits against the wal ...

ccyounger
Budding Browser
1 reply

Hi, newbie here. I bought a Specrite FJ Panel (Pine) to make an outside table and benches. I have chosen my stain (water-based, designed for exterior ...

Takatala
New Contributor
5 replies

Hi, we’ve purchased a 2 level cubby house from kidzshack - fun shack with mud kitchen. Basically it’s a raised cubby house ...

steve0
Occasional Browser
1 reply

Hi i am building a floating deck that is 3.6m X 3.6m with a walkway of 3.1m X 1m adjoining the right side and i wanted to know what framing timber i ...

markhor
Regular Browser
1 reply

can anyone advise the most appropriate backing board , must withstand the element and be suitable for stone wall cladding to be applied to. approx are ...