Garage and Shed

  Appreciate any insights on retrofitting foil board to shed ceiling. There are surprisingly few reputable sources of information on this and the f ...

Hi guys. I've just cut some pine on my mitre saw, but the 140 wide pine was just too big for my old saw. I flipped the wood, lined it up and cut agai ...

Hi all, i want to install steadyrack classic version in my garage. However when i drilled 2 pilot holes (cirled in blue in the photo) at where studs w ...

Hi All, I'm looking for ways to salvage this external garage door that is just a year old. After installation of the door, it seems like the painter ...

I'm preparing to line my garage with cement sheet, and have gotten as far as putting some corflute against the tin, before adding some batts and then ...

Hi there,I'm going to install a folding desk on the inside brick wall of my garage. I will be using a drill with hammer mode. I also have a level. The ...

I have recently built a Colorbond shed and looking for some advice on sealing the shed to make it weatherproof etc. When I built the shed I installed ...

Could you please advise on how to stop storm water from entering through this exterior door? I poured a cup of water just to show how the water gets ...

See attached photos. How do I install the heavy bag?

Created this miniature beauty ,all parts from Bunnings,except the wire,which is a chain from my Mrs ,I could not get the bend radius from a normal wir ...

I am renovating a room that was built as an attachment on the back of my garage, probably as a DIY job in the '70s. The plasterboard ceiling was att ...